- Complete 230V sliding automation kit
- Gate weight up to 600kg
- Numerous operating modes
- For aluminum, wood, PVC, and iron gates
The TANKER C600 sliding gate motor is designed for users wishing to motorize their sliding gate to automate its opening and closing. It allows you to transform your gate into an electric sliding gate.
This rack-and-pinion motor is suitable for all types of sliding gates that can be motorized.
Whether for PVC, wood, aluminum, or iron sliding gates, this automatic system can be installed on all models weighing less than 600 kg.
Here are the main technical specifications of the motor:
Motor voltage: 230V – 370W
Input power: 220VAC ±10%/110VAC ±10%
Frequency: 50Hz/60Hz
Gear module: M4 Z=16 teeth
Output torque: 30.0 Nm
Nominal rotation speed: 14,000 rpm
Maximum gate weight: 600kg on level ground
Magnetic start and end stops
Environmental temperature: -25°C ~ +55°C
Protection class: IP55
Opening speed: approximately 12 meters per minute
Maximum force: 1100N
Nylon rack
Control card included in the motor.
This kit contains:
- 1 motor
- 2 4-button remote controls with protective cover. Batteries are included.
- Nylon rack (4m – 12 pieces of 33cm)
- Installation and setup manual
- 2 quick release keys in case of power outage
- 1 pair of infrared photocells with the following features:
- 'Transmitter' photocell
- 'Receiver' photocell
- Black ABS material
- Infrared with anti-glare 50,000LUX
- 1 3W LED flashing light (equivalent to 30W for an old-generation incandescent bulb)
The flashing light has the following specifications:
- Operating voltage: 12-265 VAC/DC
- Charging capacity: < 3 W
- Flashing frequency: 1 Hz
- Operating temperature: -20°C ~ +60°C
- IP rating: IP54
Tanker C600 motor features:
- Opening according to your choice: left to right (factory mode) or right to left.
- Automatic closing: After opening, the gate will automatically close after 0, 10, 30, or 60 seconds, depending on your choice.
- Pedestrian mode: The gate opens only partially and then closes after 0, 5, 10, or 30 seconds.
- Condominium mode: This mode allows for reduced settings and the configuration of up to 50 remote controls. Each remote control will control: button 1 (gate opening), button 2 (gate stopping), button 3 (gate closing), and button 4 (pedestrian mode). Each remote control will operate in the same way.
- Adjustable opening and closing sensitivity: Depending on your environment, you can adjust the opening and closing power.
- Manual gate release. With the included key, you can disengage the opening of your gate and operate it manually.
- Auto-stop. The gate stops if it encounters an obstacle.
- The motor cannot be connected to a backup battery. In the event of a power outage, manual release with two keys (included) is possible. This disengages the motor's output pinion and allows you to operate your gate freely.
You can combine this motor with photocells, a flashing light, and an opening push button. Be sure to check the electrical compatibility (voltage in Volts) of your existing accessories if they are not from our website. All our accessories are compatible with all our motors.
Installation Tips:
To successfully connect and configure your motor, proceed step by step and check that it's working properly between each step. If you're adding accessories to your C600 motor, check that your motor is working properly each time. Finally, make sure your electrical wiring is clean. This will help you with your installation and prevent electrical leaks.
Our Casanoov technical team is here to assist you if needed.
Download the assembly instructions (PDF)
